ALTICOR Solid Surface is made with a composition of PMMA+ MMA+ High Performance Polyester Resins, ATH, Poly Chips, Pigments, Binders, Additives etc.
This gives Alticor a superior finish.
6mm thickness comes in width of 760mm by length 2500mm.
12mm thickness comes in width of 760mm by length 2500mm or 3100mm or 3700mm.
**Customized Length is possible subject to minimum order quantity.
NOTE: The information provided is designed to provide support in fabrication, installation and/or to ensure performance of Alticor solid surface. This information is intended for person or persons having knowledge of this technical area. None of the contents, including but not limited to the instructions, recommendations, and graphics, Technique, and guidelines should be understood as implying of legal, warranty or any types of liability by manufacturer and its affiliates/associates.
Clean with damp cloth/sponge. When basic stains occur, clean with mild detergent or general all-purpose cleaning agent. Ensure periodically to use mild abrasive cleanser in round motion to maintain its uniform appearance and shine.
Avoid direct contact of Alticor with strong chemicals that can cause damage like oven cleaners, paint remover etc. If exposed, immediately rinse with water. Continuous contact with tough/harsh chemicals can cause damage to Alticor surfaces. Refer chemical resistance chart before installation.
Never/avoid placing hot items directly on the Alticor solid surface. Always use trivets or rubber mats/steel plates etc. to avoid direct contact of the hot substances with the solid surfaces.
Removals of stains/scratches
To remove mild stains, scratches, scrub the area in round motion with mild abrasive cleaner. Deep scratch, stains or other damages will require professional attention and get in touch with the local Alticor certified fabricator. Always use cutting board to avoid direct contact with the Alticor surfaces.